Test printing
39
Loading the media to the Take-up Unit
[1]
Move the MANUAL switch on the rear tension unit to the NORMAL
side and pull the roll media out about 1.5 m.
[2]
Let the media that you pulled out drop in front of you.
Place the media setting plate in the center of the media.
Note
The media setting plate is supplied with the printer.
Important!
If the thickness of the media that you wish to set is 1.0 mm or more, do
not use the media setting plate.
[3]
Wrap the roll media around the media setting plate and pass the
media through the media feed slot.
Note
Insert the media into the media feed slot until the whole media setting plate is visible
from the front side.
[4]
Pull out the media setting plate from the front side.
Pull the media out several times until it reaches a length of about 1 m.
Note
• If you continue pulling the media longer than a certain amount of time, the red lamp
on the rear tension unit will light up.
The rear tension unit will stop. Set the AUTO switch of the rear tension unit to OFF
and select either INSIDE ROLL or OUTSIDE ROLL depending on the media rolling
method.
Operation manual “When the red lamp lights up” P.29
• After you pull it out, remove the board, and remove the wrinkles from the media.
[5]
Adjust the position of the roller so that the edge of the media on the
roller is straight when seen from behind.
Note
Adjust both edges of the media.
NORMAL
Summary of Contents for MUTOH VJ-1938TX
Page 55: ......
Page 56: ...VJ1938TXE Q 04...