Assembling
23
[5]
Put the cable to connect the Take-up System with the printer through
the rear side.
• A: Untie the cable that is coming out of the printer’s board box.
• B: Put the cable through two clamps on the path.
[6]
Put the cable to connect the Take-up System with the printer through
the rear tension unit (Home side).
• A: Put the cable through one clamp on the path.
• B: Put the cable through the grommet.
• C: Put the cable through one clamp on the path.
[7]
Connect the cable to connect the Take-up System with the printer to
the controller board.
• A: Put the cable around the clamp on the path once.
• B: Connect the cable connector to [J20] on the controller board.
[8]
Attach the rear tension unit (Home side) cover using six screws (Cap
screw M3 × 6).
Important!
• Before attaching the cover, pull the cables through the grommet
slowly to pull out the excess cables inside the cover.
• Make sure you do not cut the cables by the cover.
[9]
Attach the paper core to the front roll unit.
• This completes assembly.
B
A
B
A
C
B
A
Summary of Contents for MUTOH VJ-1938TX
Page 55: ......
Page 56: ...VJ1938TXE Q 04...