Setup
33
Step 3 Initial ink charging
[1]
Turn the printer ON.
[2]
The printer starts the initializing operation.
[3]
Press the [Enter] key when the message on the left appears.
The message on the left will appear.
• Press the [Enter] key.
Note
• Cleaning may be required depending on the ink type to be set.
• If you need to perform a head cleaning and “Wash retry? No” is displayed, press the [ - ] key to change the display to “Wash retry? Yes” and press the [Enter]
key. After that, follow the instructions displayed on the operation panel.
When cleaning is complete, “Insert InkCartridges” is displayed. Proceed to step 4 in this section.
The message on the left will appear.
[4]
Open a new ink bag and shake it as described below.
• Turn the ink plug upward and wait for three seconds.
• Next, turn the ink plug downward and wait for three seconds.
• Repeat that three times.
You need the following ink bags.
4-color setting:
• Black (K): 2 bags
• Cyan (C): 2 bags
• Magenta (M): 2 bags
• Yellow (Y): 2 bags
7-color setting:
• Black (K): 2 bags
• Cyan (C): 1 bag
• Magenta (M): 1 bag
• Yellow (Y): 1 bag
• Orange (Or): 1 bag
• Green (Gr): 1 bag
• Blue (Bl): 1 bag
[5]
Slide the smart chip card into the tab on the high-capacity ink pack
adapter to install it.
Note
The High-capacity ink pack adapter is sold separately.
Start Ink Charge
->
Enter
Wash retry?
No
Insert InkCartridges
3 sec.
x 3
3 sec.
Summary of Contents for MUTOH VJ-1938TX
Page 55: ......
Page 56: ...VJ1938TXE Q 04...