18
Assembling
2.
Installing the Take-up Unit to the Printer
[1]
Loosen the screw with a handle on the front roll unit, and then move
the front roll unit to the center of the rail.
• Once the unit is moved, tighten the screw with a handle.
• Move the front roll units on both sides.
[2]
Place the Take-up Unit on the stand.
Note
• Place it so that you can see the screw holes of the stand (four on each side, a total of
eight) through the screw holes of the Take-up Unit.
• Do not hold the tension roller (shown by the arrow A).
Place the front roll unit (drive) so that it is on the waste fluid tank side.
[3]
Move the stand so that the projection parts of the stand fit the two
holes on the back of the rail part.
[4]
Once the projection parts fit the holes, move the stand to check that the parts firmly fit and do not move.
[5]
Secure the Take-up Unit to the stand using eight screws (Pan-head
screw with spring washer and flat washer M4 × 12).
A
Summary of Contents for MUTOH VJ-1938TX
Page 55: ......
Page 56: ...VJ1938TXE Q 04...