Assembling
21
[4]
Connect the take-up switch cable (label: J2) to the feeding switch
board.
• A: Secure the earth wire to the earth terminal using one screw (Pan-head
screw with spring washer and flat washer M4 × 6).
• B: Put the cable through bottom clamp.
• C: Put the cable around the upper clamp once.
• D: Connect the cable connector to the connector [J2] on the feeding switch
board.
[5]
Put the cable for the slack detection sensor through the front side to
the rear side.
• A: Untie the cable, and then put it through one clamp.
• B: Put the cable through one clamp on the path.
• C: Put the cable through the grommet.
Note
The slack detection sensor is on the front side.
[6]
Connect the cable for the slack detection sensor to the controller
board.
• A: Put the cable through the bottom clamp.
• B: Put the cable around the upper clamp once.
• C: Connect the cable connector to [J13] on the controller board.
[7]
Put the take-up motor cable (label: W_MOT) through one clamp.
• A: Untie the cable, and push it from the outside of the stand to the inside.
• B: Put the cable through one clamp on the path.
Note
The take-up motor cable is the cable that is coming out of the front roller (drive).
[8]
Put the take-up motor cable (label: W_MOT) through the front side to
the rear side.
• A: Put the cable through under the printer (dotted line) and pass it through
one clamp of the rear tension unit.
• B: Put the cable through 2 clamps on the path to make it face the outside of
the stand.
• C: Put the cable through the grommet.
Note
The take-up motor cable is the cable that is coming out of the front roller (drive).
B
A
C
D
A
B
C
B
A
C
B
A
B
A
B
C
Summary of Contents for MUTOH VJ-1938TX
Page 55: ......
Page 56: ...VJ1938TXE Q 04...