Software Switch Settings – RoboSHOT 40 UHD Only
On the RoboSHOT 20 UHD, these settings are available using the physical switches on the back of the
camera. See
Camera Behavior Settings for RoboSHOT 20 UHD
S
YSTEM PAGE
, DIP S
WITCHES TAB
n
IR Settings (Camera ID)
– The IR Remote Commander can control up to three cameras in the same
room with different IR frequencies. Use the IR Settings switches to select the frequency to identify the
camera as camera 1, camera 2, or camera 3. Refer to the settings table beside the soft DIP switches.
n
IR On/IR Off
– Enable/disable the camera's IR sensors. The camera does not respond to the IR remote
if IR is off.
n
Image Flip
– If mounting the camera upside-down, set IMAGE FLIP ON.
n
Baud Rate
– RS-232 serial communication rate (9600 bps or 38400 bps), for communication with a
controller via a OneLINK device.
52
Complete Manual for RoboSHOT 20 UHD and RoboSHOT 40 UHD Professional PTZ Cameras
