Camera Behavior Settings for RoboSHOT 20 UHD
DIP switches on the back of the RoboSHOT 20 UHD set its basic behaviors.
Note
When the camera is not inverted, DIP switches are in their default positions when they are up.
IR1, IR2, IR3 (Frequency Selection):
If there are multiple cameras in the room, use
switches 1 and 2
to
configure each with a different IR frequency to allow the IR Remote Commander to control them
independently. Then use the Camera Select buttons at the top of the remote to select the camera you want
to control.
n
SW1 and SW2 up: IR frequency 1
n
SW1 down, SW2 up: IR frequency 2
n
SW1 up, SW2 down: IR frequency 3
IR:
Leave
switch 3
UP if the IR remote will be used.
Image Flip:
If mounting the camera upside-down, set
switch 4
DOWN: IMAGE FLIP ON.
Baud Rate:
Set
switch 5
to the baud rate of the device connected to the RS-232 port. The default is 9600
bps. The 38400 baud setting is optional if the connected control device supports it.
Switch 6
is not currently used.
Note
On the RoboSHOT 40 UHD, these settings are available using the corresponding soft DIP switches on the
System page of the web interface. See
Software Switch Settings – RoboSHOT 40 UHD Only
.
8
Complete Manual for RoboSHOT 20 UHD and RoboSHOT 40 UHD Professional PTZ Cameras
