Vacon X5, User Manual

Page: 72 / 140

X5 AC Drive User’s Manual Chapter 7: X5 Parameters
DPD00089A - 70 -
© 2009 Vacon Incorporated All Rights Reserved
Chapter 7: X5 Parameters
7.1 Introduction
The X5 AC drive incorporates a comprehensive set of parameters that allow you to configure the
device to meet the special requirements of your particular application.
Note that pressing the PROG key enters Level 1 programming. Press SHIFT+PROG to enter Level
2 programming. Press ENTER+PROG to show only those parameters that have changed from the
factory default values.
This chapter describes the available parameters and the values that may be assigned to them. The
parameter summary table at the front of this manual provides a summary of all parameters including
their ranges and default values.
Note that all parameters can be addressed by adding 40000 to the parameter number. For
example, parameter 201 (Input Mode) can be addressed by Modbus address 40201 .
7.2 Level 1 Parameters
The most commonly configured X5 parameters are stored in a group named Level 1. This group is
easily accessed by pressing the PROG key as described in “Chapter 5: Operation and Programming”
on page 44. The following table lists the parameters in this group; for further information on the
parameter, please turn to the indicated page.
.
Table 7-1: Parameters Available in Level 1 Programming (Factory Macro)
Para. # Parameter Name
See
Page Para. # Parameter Name
See
Page
001 Model Number 71 303 Preset Freq 1 79
102 Output Freq 72 402 Accel Time 1 81
103 Output Voltage 72 403 Decel Time 1 81
104 Output Current 72 502 Voltage Boost 85
105 Drive Load 72 610 Timed OL Select 90
106 Load Torque 72 700 Vmet Config 91
107 Drive Temp 72 705 Relay 1 Select 93
111 DC Bus Voltage 72 706 Relay 2 Select 93
201 Input Mode 75
202 Rev Enable 75
301 Min Frequency 79
302 Max Frequency 79