Fig. 87: Dry mortarless installation into a half-timbered construction, with a fire batt, flange to flange, illustration
shows side by side installation (applies also to installation of dampers on top of each other)
1
FKRS-EU
2.4
Fire batt with ablative coating
3.5
Half-timbered construction, cladding on both
sides
4.1
Solid ceiling slab / solid floor
6.8
Infill (cavities completely filled with mineral wool
≥
1000 °C,
≥
50 kg/m³, or bricks, aerated con-
crete, lightweight concrete, reinforced concrete
or clay)
6.10
Ablative coating around the perimeter,
d = at least 2.5 mm
6.24
Elastomeric foam (flame-resistant, non-drip-
ping)
The following applies in Germany: For notes
on the use of elastomeric foams, see
.
7.9
Half-timbered construction
7.11
Trim panels, fire-resistant, double layer, stag-
gered joints
7.13
Cladding
7.14
Reinforcing board of the same material as the
wall
*
6.19, 6.20 or 6.24 as an alternative
**
Installation near the floor analogous to
Installation
Lightweight partition walls with timber support ... > Dry mortarless installation with fire batt
Fire damper Type FKRS-EU
104
Summary of Contents for FKRS-EU
Page 176: ...Fire damper Type FKRS EU 176...
