Triumph Daytona 955i, Service Manual

Page: 359 / 375

-31A
16 ELECTRICAL SYSTEM
T
► ` 1 !! H
LICENCE PLATE LIGHT
Bulb Replacement
1.
Remove the rear bodywork, as described in the
body section, to gain access to the licence plate
light unit.
2.
Carefully remove the rubber bulb holder from the
back of the light unit.
CAUTION: Do not pull the bulb holder out
by means of the electrical wires.
3.
Replace the bulb and fit the bulb holder to the
li ght unit.
4.
Refit the bodywork and seat(s) as described in
the body section.
TAIL LIGHT
Removal
1. Remove the seat(s)
2. Disconnect the battery, negative (black) lead first.
3.
Release the fixings securing the light to the rear
body panels.
4. Rotate the bulb holders anti-clockwise and detach
from the light unit.
5. Withdraw the light from the bodywork.
Installation
1. Locate the light to the rear body panel.
2. Refit and tighten the fixings to secure the lamp to
the body panel.
3. Refit the bulb holders to the light and turn
clockwise to lock into place.
4. Reconnect the battery, positive (red) lead first.
5. Refit the seat(s)
Bulb Replacement
1. Bulb Retainer
1. Remove the seat(s)
2. Disconnect the battery, negative (black) lead first.
3. Rotate the bulb holders anti-clockwise and detach
from the light unit.
4. Detach the bulb from the bulb holder.
16.18