Triumph Adler DC 2045, Instruction Handbook Manual

Page: 233 / 244

Section 9 TROUBLESHOOTING
9-17
4. If other trouble occurs
Trouble
Nothing lights on the
operation panel when the
main switch is turned ON.
No copies come out when
the [Start] key is pressed.
The copies come out blank.
The copies come out too
light.
If trouble occurs with your copier, carry out the applicable checkpoints and procedures indicated on the following pages.
If the trouble persists, contact your service representative or authorized service center.
Checkpoint
Is the power plug connected to an AC
outlet?
Is there an error message on the touch
panel?
Were the originals set correctly?
Is the copier in the auto exposure mode?
Is the copier in the manual exposure mode?
Is a message that tells you to add toner
displayed?
Is the copy paper wet?
Procedure
Connect the plug to an AC outlet.
Check the appropriate response to that
message, and perform the corresponding
procedure.
When setting originals on the platen, set
them face-down.
When setting originals in the Document
Processor, set them face-up.
In order to adjust the overall exposure level,
perform the “Auto exposure adjustment”
procedure.
Adjust the exposure to the correct level
using the copy exposure adjustment keys.
To adjust the overall exposure, adjust the
exposure for each image quality mode.
Add toner.
Replace the copy paper with new paper.
Reference
page
——
9-1
3-7
3-6
7-47
4-2
7-49
7-50
7-51
3-8
3-1