Pag. 20
DUALCOM-8 INSTALLATION MANUAL
ENGLISH
After having installed sensors in each zone and after making sure that this installation has been done
correctly, set the parameter of each zone and at the end press the
【
#
】
key to confirm. In case of
doubts, it is best to repeat the programming sequence rather than risk malfunction of the panel.
Example of zone parameter settings:
Zone 1 must be set for:
1. (5) Burglary Alarm
2. (1) Zone is controlled by Arm/Disarm
3. (0) Zone is immediate
4. (2) Outdoor wireless siren is active
5. (1) Siren sound is continuous
6. (1) Keypad alarm buzzer is in function
7. (1) Panel set for night mode
8. (2) Alarm response time set for 500 mille seconds
9. (1) Alarm trigger set for normally closed contacts
10. (0) Alarm set for the Area 1 trigger only
Setting on the display must be as shown below:
After setting is terminated press
【
#
】
to confirm.
03.02 Setting of the 2nd. to the 24th hardwire zone follow the procedure below:
In the menu for the management of the hardwire zones
,
press the digits:
【
(02-24)
】
+
【
#
】
or go up and down with the keys:
【
】
or
【
】
Follow the setting indications shown in section 03.01.
Carefully digit on keypad the programming sequence and at the end press the
【
#
】
key to confirm.
Wired zone
<01>5102111210
