Page
152
Program 75-Num-IP : LCR - Analysis Table
75-Num-IP Dg Tab
---------- 00
Num = Number (001-500)
Value for each Item
IP
Value
Default Item Description
01-10
0~9, *,#,_,d _,_,..,_
Number of routing analysis
11-12
01~20
00
Routing Table
General:
This program assigns the routing table for the specific dialled number.
Description:
500 specified dialled numbers can be assigned.
20 routing tables can be used.
Each specified dialled numbers must be assigned to a routing table (routing tables are in Mode 76).
The dialled digits could be 0~9, *, #. ‘d’ is the wildcards. ‘-‘ means no digit.
When a number is analysed and entered into mode 75 the entry must be complete to the end of the entry.
If the digit 1 is entered for example it must be followed by ddddddddd to the end of the entry.
Related system Programming: 05-13-07. 05-13-08, 75, 76, 77, 78-st-01, 78-st-02
All numbers that need to be dialled have to be analysed in Mode 75 and allocated to a route in Mode 76 to
allow the digits to be dialled correctly. Do not forget to allocate a route to 000 as a priority to make certain
that this route is not blocked.
Even if a number is not to be modified or rerouted in any way it should be allocated in Mode 75 to go to a
route table in Mode 76 which will allow it to select a trunk and dial out using default settings.
Call flow is as follows.
A call is analysed in mode 75 and sent to mode 76.
In mode 76 if the call is to be handled the same 24 hours a day then it should be assigned in part C which
has no start or finish time.
The call is assigned a dial 9 group and then sent to a modify table in mode 77 if required.
If the call is to be assigned to a route that has a limited number of available trunks the call can be
programmed to a second route if all available trunks in the first route are in use. The second (and third
and fourth) routes can assign a trunk group and a modify table each.
If a call is assigned to a Modify table in mode 77 the modify table can if needed remove a specified
number of digits from the leading edge of the number and then insert up to 12 digits in their place or it can
leave the number intact and insert the digits in the leading edge.
When the LCR programming is complete the feature should be enabled station by station in mode 78-stn-
01/02
Summary of Contents for Lynx DK6 Series
