TransTel Communications Lynx DK6 Series, Master Programming Manual

Page: 139 / 185

LYNX Plus Programming Manual Rev 2.1c Page
139
06. Door Unlock / DND / CFWD Access
This parameter allows or disallows the station from accessing the Door Unlock, Do Not Disturb (DND) and
Call Forward (CFWD) features as per the table.
IP \ Value 0 1 2 3 4 5 6 7
Door Unlock Disallow Allow Disallow Allow Disallow Allow Disallow Allow
DND Disallow Disallow Allow Allow Disallow Disallow Allow Allow
CFWD Disallow Disallow Disallow Disallow Allow Allow Allow Allow
07. ACP Door Phone Hunt Group / Permanent Call Forward Group – No Answer
IP \ Value 0 1 2 n 9 d
46-st-07 Group 1 Group 2 Group 3 Group n+1 10 Program 3
This parameter allocates the Station Hunt Group that the ACP will call if it is programmed as a Door
Phone and the Call button is pressed. When setting is d; the ACP will call the extension according to the
assignment in Program 3: Door Phone Ring Assignment
If the Extension is not an ACP then this parameter sets the Permanent Call Forward destination Hunt
Group on No Answer. If the Station user sets a Call Forward manually then it will override this setting but
after cancelling the manual Call forward then this setting will be enabled again.
See also Mode 78-st-04: Call Forward Group - Busy.
08. SLT Ring Cadence Settings
If the Station is an SLT then this parameter will set the ring Cadence for calls as follows.
IP \ Value 0 1 2 3 4
46-stn-08 Normal Always Trunk ring pattern Always Intercom ring pattern Special Ring Fax Ring