LYNX Plus Programming Manual Rev 2.1c
Page
33
connector. Attention to proper cabling will go a long way towards a successful installation and minimizing
service calls after installation. Some guidelines for running station cable are as follows:
Avoid running cable parallel to fluorescent light fixtures or electrical lines not in conduit. If these
obstacles are unavoidable, run the cable at right angles across them.
Do not run station cable inside conduit already occupied by electrical wiring.
Do not run station cable near equipment with electric motors or strong magnetic fields.
Do not place station cable on the ground where it can be stepped on or rolled over by office furniture
or office equipment.
Digital Key Telephone –DK6 - DK7
A cable cover is provided with the KSU. Station cables enter from the bottom of the KSU. Remove
the cover and route the station cable through the hole. Terminate the station wires with the
connectors that are provided. The stations will connect to the KSU as shown on the main panel
(above) on connector locations ST1~ST4 (port11~port14).
Connect the stations to Inner pair for Port 1 and outer pair for Port 2 of the DDK connector.
Connect Tip terminal with GRN terminal (screws) of the modular jack, Ring with RED.
There is no polarity requirement on Tip and Ring.
2-conductor wiring is required for DK series Digital Key Telephones.
Select the 1
st
station position. ALL phones are to be set to this position for the Lynx
For DK6 and DK7 phones the switch is on the underside of the phone and should always be set to
first position.
CAUTION!:
Avoid shorting Tip and Ring together. It may damage the G1K-MBU or G1K-TLU board.
Summary of Contents for Lynx DK6 Series
