Installation - Zone Sensors
UNT-SVX07E-EN
73
Changing Heating/Cooling Settings
(does not apply to all systems)
Changing Fan Settings
Requesting Temporary Occupancy
Error Codes
Lock Symbol
Testing Signal Strength
Testing Battery Status
Some systems allow
you to select both
heating and cooling
room temperature
settings. If your
system has this
option, this symbol
appears when you
adjust the
temperature setting.
1.
Press
or
to
select the heating/
cooling setting.
2. If in cooling mode, press
to change to heating
mode. If in heating
mode, press
to
change to cooling
mode.
3. Press
or
to
select the heating/
cooling setting.
4. To confirm, press
or
wait 5 seconds. The
home screen will
appear.
When you adjust the
cooling setting, the top
arrow and snowflake
flash.
When you adjust the
heating setting, the
bottom arrow and
flame flash.
Indicates that the
fan will operate as
needed to reach
the selected
temperature.
1.
From the home screen,
activate the fan setting
menu by pressing
and then
.
2. Press
or
to choose
the desired fan setting.
3. When the symbol for the
desired setting appears,
confirm your choice by
•
Pressing
(the
home screen will
appear), or
•
Pressing
or
(the next menu
will appear), or
•
Waiting five seconds.
Indicates that the
fan setting is On.
The number of
arrows indicates
fan speed
(3: high, 2:
medium, 1: low).
The example
shown indicates a
fan on high speed.
Not all systems
offer all three
speeds.
Indicates that the
fan setting is Off.
Fan Menu
Select to
request
occupancy
•
If you need heating or cooling after
normal business hours, you can
“request” temporary occupancy by
pressing
and holding it for
2 seconds. The occupied symbol
remains on the screen and the
unoccupied symbol disappears.
After 30 seconds, the unoccupied
symbol will re-appear.
•
To cancel temporary occupancy,
press
and hold for 2 seconds. The
unoccupied symbol will remain on
the screen and the occupied symbol
will disappear. After 30 seconds, the
occupied symbol will re-appear.
Select to
cancel
occupancy
Indicates an
error code
If an error code (E0–E7) is displayed,
technical assistance may be required.
Indicates
that a setting
is locked
The lock symbol appears if you try to
adjust a setting that cannot be
changed.
Indicates
excellent
signal
strength
Indicates
satisfacto
ry signal
strength
Indicate
s poor
signal
strength
Press the Test button to display the signal strength
symbols.
Indicates full
battery power
Indicates 50
percent of
battery life
left.
Indicates 25
percent of
battery life left.
Replace
batteries.
Flashing symbol
indicates that
approximately 14 days
of operation remain.
Press the Test button to display the battery status symbols.
Use only UL-listed non-rechargeable 1.5 V lithium AA
batteries (Trane p/n X13770035010 or equivalent).
