Installation - Zone Sensors
70
UNT-SVX07E-EN
Wireless Display Sensor (WDS)
Configuration Procedure
Note:
Sensors shipped with the fan coil are pre-
configured for three speeds.
The configuration of the sensor determines which system
features can be accessed and changes can be made by the
tenant (for example, changes to cooling/heating mode,
setpoint, or fan speed. Verify system and associated unit
features before configuring the sensor.
The building owner or operator may choose to limit tenant
access to certain features. This can be done through
configuration. Or, if a sensor is configured to match all
control capabilities of the building automation system, the
locking feature can be used to restrict the tenant from
making changes.
To configure settings on the wireless display sensor
(WDS), follow this procedure in the order presented.
1.
Press the configuration button for three seconds.
The display will change to configuration mode. When the
sensor is in configuration mode, a wrench symbol appears
on the display and the menus are separated by lines, as
shown in
Figure 60
.
2. Press the center button on the keypad to begin the
configuration process.
3. Configure the sensor options in the order shown in the
table.
•
Press
or
to scroll to the next selection (as
illustrated).
•
Press
or
to move to the next menu (as
illustrated in
Table 25
).
4. Review the display to ensure that you have selected the
correct configuration.
5. To return the display to operating mode, press the
configuration button (see
Step 1
).
Note:
The sensor will revert to operating mode if no
buttons are pressed for 10 minutes.
Figure 59.
Configuration button
Configuration
button
Figure 60.
Wrench is shown in configuration mode
Figure 61.
Center button of keypad
Wrench
Center
button
