Toshiba B-SX4T Series, Specification

Page: 51 / 374

- 47 -
NOTES: 1. If the head is being lifted when the edge of the label which is being
ejected passes the paper feed roller, the sensor may not be able to
detect an error even if it occurs (a feed cannot be performed).
2. If the head-up solenoid temperature is high when a cut issue is
about to be performed with the head lifted, the head may not be
lifted.
[Method 2] Adjust the cut position value.
When this procedure is used, one or more printed labels are left between the
head and the cutter. Therefore, these labels should be removed by an issue or
a label feed.
(a) Cut position fine adjustment value calculation
The cut position fine adjustment value can be calculated using the following
method. If a back feed to the proper home position cannot be performed
using this value, the cut position should be adjusted with any value.
Ex) Label pitch: 30.0 mm
Label pitch
(Label pitch)
32.8 mm
* Any decimal remainders
are dropped.
× (Label pitch)
Cut position fine
adjustment value
=
=
(Number of labels left
between head and cutter)
×
32.8 mm
30.0 mm
× (30.0 mm)
Cut position fine
adjustment value
=
= 1 × 30.0 mm
= +30.0 mm