Toshiba B-SX4T Series, Specification

Page: 268 / 374

- 264 -
(5) Head Open Error
c If the head open sensor detects the open state in 5 mm continuously, an error will result.
d If the head open sensor detects the open state when an issue, a feed, or an ejection is
attempted in a printer stop state, an error will result.
e If the head-up sensor detects the head-up state in 5 mm continuously, an error will result.
f If the head-up sensor detects the head-up state when an issue, a feed, or an ejection is
attempted in a printer stop state, an error will result.
However, the feeding by the [FEED] key on the printer and the issuing and feeding by the
expansion I/O are not included.
(6) Thermal Head Error
c A broken dot error has occurred in the thermal head.
d An error has occurred in the thermal head driver.
(7) Thermal Head Excessive Temperature
c When the open-air temperature detection thermistor detects an excessively high temperature
(61 °C or more), an error will result.
d When the thermal head temperature detection thermistor detects an excessively high
temperature (80 °C or more), an error will result.
e When the heat sink sensor detects an excessively high temperature (91 °C or more), an error
will result.
(8) Ribbon Error
c When the ribbon rewind motor sensor and ribbon back tension motor sensor do not perform
detection if twice the prescribed time has passed, an error will result.
• An abnormal condition has occurred in the sensor for determining the torque for the ribbon
motor.
• A ribbon jam has occurred.
• The ribbon has run out.
• The ribbon has not been installed.
(9) Rewinder Overflow
c If the rewinder overflow sensor detects the overflow state in 5 mm continuously when the strip
function or the built-in rewinder is specified, an error will result.
d If the overflow sensor detects an overflow state when an issue, a feed, or an ejection is
attempted in a printer stop state after the strip function or the built-in rewinder is specified, an
error will result.
* At the moment an error occurs, the printer shows the error message, makes a status response,
and then stops. Only the Status Request Command and the Reset Command can be
processed. Other commands are not processed. Restoration using the [RESTART] key is
possible except in the case of a thermal head excessive temperature error. (The printer
resumes printing a label at which the error had occurred.)