Toro 04861, Service Manual

Page: 146 / 234

Removing the Reel Cable (continued)
g336875
Figure 81
1. Retaining ring 3. Jam nut
2. Reel selector assembly 4. Reel cable
3. Remove the reel cable (item 4 in Figure 81 ) from the reel selector assembly
(2) as follows:
A. Loosen the front cable jam nut (3) and lift the reel cable (4) from the
casting slot of the base.
B. Remove the retaining ring (1) that secures the reel cable eyelet to the reel
selector assembly (2) and slide the reel cable eyelet from the selector
assembly.
4. Remove the control cover and lower cover from the handle assembly to allow
access to upper end of the reel cable.
5. Remove the reel cable (item 1 in Figure 80 ) from the traction bail assembly
as follows:
A. Loosen the lower cable jam nut (2) that secures the reel cable (1) to the
upper receiver weldment (12). Slide the cable from the upper receiver
weldment.
B. Remove the cable spring (3) from the clevis connector (10) on the reel
lever assembly (5). Note the orientation of cable spring hook on the shaft
assembly for assembly purposes.
6. Remove the reel cable (1) from the machine.
Installing the Reel Cable
1. Secure the reel cable (item 1 in Figure 80 ) to the traction bail assembly as
follows:
A. Install the cable spring (3) to the clevis connector (10) on the reel lever
assembly (7). Orientate the cable spring hook end toward front of the
machine.
B. Slide the cable (1) into the upper receiver weldment (12). Ensure that the
jam nut (2), flat washer and lock washer are on both sides of the bracket.
Adjust jam nuts so that equal amount of cable threads are visible above
the jam nuts. Leave the jam nuts snug until final cable adjustment.
2. Route the reel cable to the reel selector assembly (item 2 in Figure 81 ) and
install the reel cable (4) as follows:
A. Slide the cable eyelet to the reel selector assembly (2) and secure with
a retaining ring (1).
Controls, Wheels, and Accessories : Service and Repairs Page 6–8 Greensmaster ® eFlex 1021
20248SL Rev C