Checking the Bedknife on a Granite Surface Plate
1. Place bedbar-bedknife assembly on a precision flat granite surface plate with
the cutting-edge down. Look for visible light between the granite and the
bedknife, or use a shim to test for .002 inch or greater gaps (
).
g376005
Figure 108
1.
Shim (.002 inch) to test for gaps
3.
Granite surface plate
2.
Inspect the surface between the bedknife
and granite for light
2. If there is a gap that the shim fits through, or light shows between the granite
and the cutting edge after grinding with 1 shim, regrind the bedknife with an
additional shim installed (maximum of 4 shims total, 2 per magnet); refer to
Troubleshooting Bedknife Grinding (page 7–16)
.
Greensmaster
®
eFlex 1021
Page 7–17
DPA Cutting Units: Service and Repairs
20248SL Rev C
Summary of Contents for 04861
