TOHATSU MFS 40A, Owner'S Manual

Page: 42 / 358

ENGINE OPERATION
40
7
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 rpm
for several minutes.
ENOM00 -0
Trolling engine speed control
function
If the main switch key is pressed for 1 (one)
second during idling or trolling operation,
engine revolution change.
Each time the main switch key is pressed
in the above manner, engine speed
changes as follows.
Starting
850rpm
Ѝ 750rpm Ѝ 650rpm
ЌࠉࠉࠉࠉࠉࠉࠉࠉࠉЎ
950rpm Ћ 850rpm Ћ 750rpm
Buzzer short sounded one time, when set
to 650 rpm engine speed, and tells the
lowest engine speed was set.
Buzzer short sounded twice, when set to
950 rpm engine speed, and tells the high-
est engine speed was set.
Reset the engine speed when after engine
restarted and or engine speed is above
3,000 rpm, and then trolling engine speed
to be 850 rpm as standard.
In addition, this function does not operate
when battery voltage is lower than speci-
fied, set engine idle and trolling engine
speed to 850 rpm automatically.
ENOM00046-A
ENOW00037-0
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
ENOW00038-A
z
Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
Clutch in (In gear) Clutch off (Out of gear)
850 rpm 850 rpm
ENOF00868-0
ON
1
seconds
ENOF00876-0
4. Forward, reverse, and
acceleration
WARNING
WARNING
0)6$B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸳ᖺ㸯᭶㸯㸱᪥ࠉⅆ᭙᪥ࠉ༗๓㸯㸯᫬㸲㸱ศ