TOHATSU MFS 40A, Owner'S Manual

Page: 67 / 358

INSPECTION AND MAINTENANCE
65
10
1. Drain hole
6. Tighten the oil drain screw with apply-
ing oil on the sealing surface of screw.
(Use new oil drain washer)
Oil drain screw specified torque
24Nm (17 ft
-
lb, 2.4 kgf
-
m)
ENON00028-A
Note
If a torque-wrench is not available when you
are fitting a oil filter, a good estimate of the
correct torque is 3/4 to 1 a turn past finger-
tight. Have the oil filter adjusted to the cor-
rect torque as soon as possible with a
torque-wrench.
7. Reset the engine in a vertical position.
8. Repeat 3 to 7 procedures two or three
times to drain the oil completely.
9. Remove the top cowl and the oil filler
cap.
10. Fill the engine through filler port with
recommended oil (see chart below) to
the middle of dipstick mark.
11. Tighten the oil filler cap.
1. Filler cap
2. Dipstick
3. Filler port
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 13)
1
ENOF00923-0
1
2
3
ENOF00924-0
2
1
ENOF00113-0
10W−40
10W−30
˚C
˚F
40
96 30
86 20
68 10
50 0
32
-10
14
-20
-4
-30
-22
ENOF00208-0
0)6$B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸳ᖺ㸯᭶㸯㸱᪥ࠉⅆ᭙᪥ࠉ༗๓㸯㸯᫬㸲㸱ศ