Chapter 3
SYSTEM SETTINGS (NX-300 SETTING SOFTWARE)
3-39
Control pattern
Broadcast pattern
Contact Bridge pattern
Combination of broadcasting direction
and connection destinations
Combination of control outputs
11.1. Pattern Setting Summary
11.1.1. Devices that require pattern settings
Pattern settings are performed for devices that make broadcasts from either the control input or the NX-300
Operation Software.
When starting broadcasts from the control input, select Control Pattern.
When starting broadcasts from the NX-300 Operation Software, select Broadcast Pattern.
11.1.2. Pattern type and configuration
ontrol, roadcast, and ontact ridge patterns are con gured as follo s.
The ontrol pattern is con gured by a combination of roadcast and ontact ridge patterns. t may consist
of only the Broadcast patterns or Contact Bridge patterns.
11.1.3. Control pattern setting procedure
Set both the Broadcast and Contact Bridge patterns in advance when using the Control pattern.
Step 1.
Select the unit to set using the unit list on the setup editing screen.
Step 2.
Set the Broadcast pattern.
(See
p. 3-40.
)
Step 3.
Set the Contact Bridge pattern.
(See
p. 3-46.
)
Step 4.
Set the Control pattern.
(See
p. 3-51.
)
Summary of Contents for NX-300
