Chapter 2
INSTALLATION AND CONNECTION
2-6
[Control input connection for failure detection]
The function of detecting failures in iring ith e ternal control output e uipment can only be set to control
input terminal . or iring for hich failure detection is performed, insert resistors as sho n belo
or instructions on setting the failure detection function to the control input terminal,
see p. 3- , ONT O
N
T S TT N S.
Notes
• e sure to connect resistors as sho n in the gure belo . The failure detection function ill not ork
correctly if no resistors are connected, or if resistors of different values from those specified are used.
• To ensure stable NX-300 operation, it is recommended that failure detection iring be made independent
from that of control input terminals 1 , for hich shielded t isted pair cables shorter than 10 m 3 . 1 ft
should be used.
• onnect the cable s shielded ire to the NX-300 s signal N terminal.
1
2
E
C
H
AUDIO OUTPUT
E
C
H
AUDIO INPUT
E
C
H
E
C
H
GND
SIGNAL
LAN
AC ADAPTER
DC INPUT
DC INPUT
10
9
CONTROL INPUT
CONTROL OUTPUT
1 2 3 4 5
8 C
6 7
1 2 3 4 5
8 C
6 7
ON
1 2 3 4 5 6 7 8
1 2 1 2
GND LIFT
LINE
PAD MIC
NORMAL
Wiring for which failure
detection is performed
To other unit's control output
± 5%
± 5%
Output control terminals for which failure detection is performed.
*
*
Only Control Input Terminal 8 supports the control input failure detection function.
CONTROL INPUT
1 2 3 4 5
8 C
6 7
Summary of Contents for NX-300
