Tiger 370 CNC--MR, Use And Maintenance Manual

Page: 176 / 180

MEP S.p.A.
11--2 166
Use and maintenance manual TIGER 370 CNC--MR
It must be connected to a 6 Bar pneumatic power supply and the motor is fed by
the saw control.
CHARACTERISTICS
AIR
1
0
3
BAR kw kg
6 0.37 485
Installation:
"
fit the adaptor, which is together with the motor unit, on the loading side of
the machine;
"
position the motor unit on the loading side (left) and connect it to the machi-
ne adaptor;
MEP SPA ITALY
CB 6001
"
before tightening the screws, use a ground bar and place the first module level
with the working surface, adjusting the feet;
"
fit the other two modules, by inserting the male tubes into the female ones;
MEP SPA ITALY
CB 6001
"
open the rollers that determine the load section entirely; then insert the drive
connection coupling in the crown gear of modules 1 and 2, then of modules 2
and 3;
"
fix the modules using screws and bolts in the tube holes;
"
unwind the emergency winding, located on the first module, until the device
reaches the last module; fix it using screws in an easily accessible place;
"
take the emergency mushroom, located on the first module, to the end of the
last module which is set for fixing and connecting the cables;
"
insert the power supply plug into the socket on the left---hand side of the ma-
chine;
"
connect the male terminals of the signal cables to the controller card, making
them pass through the hole in the electric cabinet with sheath and fitting, then
connect the male terminals with the female terminals inside the cabinet.