Tiger 370 CNC--MR, Use And Maintenance Manual

Page: 148 / 180

MEP S.p.A.
7--16 138
Use and maintenance manual TIGER 370 CNC--MR
"
If the feed table is not parallel to the cutting table, move the feed carriage
away from the platform, then loosen the fixing TCEI screws on the feeder
(A---B).
A
B
"
Adjust the foot height (D---E), according to the measurement read on the rul-
er on the cutting table so as to obtain a difference in level of 0.5 mm between
the two tables.
D
E
"
Once the height has been set with a standard ruler near the fixed platform,
line up the rest of the feeder using the support pins to adjust as shown in the
figure;
"
open the left door panel on the base to access the adjustment nuts and the 4
support pins;