TIGA P 901 PH, Instruction Manual

Page: 98 / 172

18
EN
ENGLISH
(Translation of the Original Instructions)
Exhaust system. No leaks at connections.
All screws tightened.
Oil lines No leaks. No damage.
Activate the machine
forwards/backwards
and release the
traction pedal.
The machine will stop.
Test driving No abnormal vibrations.
No abnormal sound.
7 .8 .2 Electrical safety check
Country/State Action Result
Driver not seated.
Parking brake
engaged.
Try to start
the engine.
The engine
does not start.
On the display
(if present)
the message
“SIT DOWN”
appears.
Driver seated.
Parking brake
disengaged.
Try to start
the engine.
The engine
does not start.
On the display
(if present)
the message
“PRESS
BRAKE”
appears.
Driver seated.
Parking brake
engaged.
Try to start
the engine.
The engine
starts.
Engine on,
cutting device
disengaged,
parking brake
engaged.
The driver
gets up
from the
seat.
The engine
stays on.
Engine on,
cutting device
disengaged,
parking brake
disengaged.
The driver
gets up
from the
seat.
The engine is
switched off..
Engine on, cutting
device engaged,
parking brake
disengaged.
The driver
gets up
from the
seat.
The engine is
switched off..
Engine on,
cutting device
disengaged,
parking brake
engaged.
The driver
gets up
from the
seat.
The engine is
switched off..
7 .9 START-UP / OPERATION
When using the machine, the bonnet
must be closed and fastened shut .
Always use full throttle when using the
machine .
1. Open the fuel cock (24:B).
2. Insert the key in the main power switch (12:A).
3. Engage the transmission (19) - (lever out).
4. Insert the key in the switch (14:C).
5. Do not keep your foot on the traction pedal
(13:C).
Cold start
1. Activate the parking brake (13:A).
2. Turn the throttle to full on (14:A).
3. Pull the choke out completely (14:B).
4. Turn the switch key to the “I” position and
press the START button (14:P).
Before starting work with the machine,
wait a few minutes for the oil to warm up .
For use in low temperatures, warm
the machine up to bring the hydraulic
fluid and the transmission to the
proper temperature . Otherwise the
transmission could get damaged .
Warm start
1. Activate the parking brake (13:A).
2. Turn the throttle to full on (14:A).
3. The choke control (14:B) needs to be lowered.
4. Turn the switch key to the “I” position and
press the START button.
To proceed see the instructions provi-
ded in headingparagrafo 7 .9 .1 .
7 .9 .1 Operation
To operate with the machine proceed as described
below:
• Press the pedal (13:A) right down then release it.
• Activate the pedal (13:C) to move the machine.
• Go to the work area.
• If front accessories have been installed, acti-
vate the PTO (14:F).
• Commence work.
7 .10 STOPPING
To stop the machine, proceed as follows:
• Press the parking brake pedal (13:A).
• Pull the lever (13:B) up.
• Release the pedal (13:A).