TIGA P 901 PH, Instruction Manual

Page: 91 / 172

11
EN
ENGLISH
(Translation of the Original Instructions)
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
a waste disposal facility in accordance with the
local regulations in force.
4 INSURING YOUR LAWNMOWER
Check the insurance on your lawnmower.
Contact your insurance company.
You ought to have fully comprehensive insurance
for traffic, fire, damage and theft.
5 ASSEMBLY
Do not use the machine until all the in-
dications provided in the “ASSEMBLY”
section have been carried out .
Unpacking and completing the as-
sembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equip-
ment .
5 .1 ASSEMBLY COMPONENTS (3)
The machine is delivered with the seat, armrests,
steering wheel, tow bar, quick-fit supports disman -
tled. The battery is in its housing and connected.
The packaging holds the components needed for
assembly (3) as listed in the table below:
[740 IOX; 540 IX]
Pos. No. Description Dimensions
A 2 Spring pin 6 x 36
B 2 Key for switch /
C 1 Key for main power switch /
D 2 Armrests /
E 4 Screws for seat fastening M8 x 40
F 10 Pegs for bellows fastening
G 4 Bushes for seat fastening
H 4 Split lock washer M8
L 4 Hex head screw M8 x 20
M 1 Carrier
N 4 TORX screws (carrier
fastening)
M6 x 20
O 1 Tow bar
P 2 Flanged nut M8
R 2 Quick-release supports
[340 IX]
Pos. No. Description Dimensions
A 2 Spring pin 6 x 36
B 2 Key for switch /
C 1 Key for main power switch /
D 2 Armrests /
M 1 Carrier
N 4 TORX screws (carrier fastening) M6 x 20
O 1 Tow bar
P 2 Flanged nut M8
Q 2 Hex head screw M8 x 20
R 2 Quick-release supports
S 2 Seat fastening pin M8
5 .2 SEAT
Install the seat following the instruc-
tions in the following order .
5 .2 .1 Armrest assembly (6)
You will find the armrests and the components for
their installation in a separate box in the machine
packaging.
5 .2 .2 Seat assembly (5) (Mod . 740 IOX, 540
IX)
1. Smear oil over the 4 sliding runners (5:A).
2. Prepare the 4 screws (M8 x 40) by inserting
them in the spring lock washers and bushes.
See (5:B).
3. Lift the seat support (5:C) to an upright po-
sition.
4. Bring the seat towards the support and insert
the assembly (5:B) in the slot (5:D) on the
support.
5. Make sure the seat is right up against the
support and position it so that the holes for
the fixing screws are about halfway along the
sliding runners.
6. Insert and tighten the 4 screws (5:B).
7. Fasten the screws, tightening torque 20÷25
Nm.
Tightening the screws to a torque over
25 Nm, will damaged the seat .
8. Connect the seat connector (5:E) to the wiring
connector (5:F).
If the connectors are not connected the
machine will not work .
9. Pass the wiring cable in the fastening clip
(5:H) to hold it in position.