Thermo Scientific IMP 180, Manual

Page: 76 / 118

Handling and Control
Settings
7-22 Heratherm IMP Thermo Scientific
Program Preferences
The Settings ->Program menu item supports the preferences described in the following for
the execution of user programs (see “Programming” on page 7-37 ) used to control the
operations. When a program terminates after running through one or more program cycles
(see the section
“Program Cycle Prompt” below), a single audible signal consisting of 5 beeps is
given when no error condition is present. The is then switched off, unless the user has set the
preferences to keep it running, as explained in the section
“Mode after End (of Program)” on
page 7-23 .
Program Cycle Prompt
This menu item allows for enabling a prompt (deactivated when the ships from the factory)
that asks for the number of times a program should be repeated (see
“Launching a Program”
on page 7-26 ) whenever the user launches a program.
Table 7-25 Activating / Deactivating the Program Cycle Prompt
Press to activate the menu bar, then use or
to select the
Settings
icon and press to
confirm.
The
Error
menu item from the
Settings
submenu
appears in the multifunctional display pane.
Press to switch to the
Program
menu item and
confirm the selection with .
In the selection screen that appears, choose the
preselected option
Loops
by pressing .
2010-04-06 1:33
PM
Settings
Error
2010-04-09 13:43
PM
Settings
Program
2010-04-09 13:43
PM
Settings
Program
Loops