Thermo Scientific Barnstead GenPure xCAD Plus System, Operating Instructions Manual

Page: 45 / 128

7
Installation
Installation of GenPure xCAD Plus system, wall version
Thermo Scientific GenPure
39
12 Mount the feedwater connecting kit together and
connect it to the feedwater inlet line. Connect the
other end of the hose to the feedwater connector
of the system by unscrewing the fitting. After this
put the hose through the fitting and mount the
white O-ring on it. Screw the fitting back to the
system.
Only feedwater that has been pretreated by
reverse osmosis, ion exchange or distillation is to
be used.
13 Connect the 0.31” (8 mm) o.d hose to the rinse
water connection of the system (see step 11) and
make a gravity fall (pressureless) connection from
the system to the floor drain. The drain to the
sewer must be max. are 1m (1.09 yards) above the
rinsing water connector of the unit.
14 Screw the final filter in counter clockwise
direction (see red arrow in the picture) into the
1/4" female thread of the xCAD dispensing valve.
Step Action Figure
Feedwater
connecting kit
Fitting
Feedwater
connector
unit
Hose 0.31”
8 mm
o.d
White
O-ring
Rinse water
connection
White
O-ring
Hose 0.31”
8 mm o.d
Fittin
g
1/4" female thread
connection
Final filter 0.2 μ m