Thermo Scientific Barnstead GenPure xCAD Plus System, Operating Instructions Manual

Page: 43 / 128

7
Installation
Installation of GenPure xCAD Plus system, wall version
Thermo Scientific GenPure
37
5 a. Connect the one end of the 0.31”
(8 mm) od hose to the xCAD flow
connector on the system by unscrew the
fitting. After this put the hose through
the fitting and mount the white O-ring
on it. Screw the fitting back to the
system.
b. The other end of the 0.31” (8 mm) o.d
hose you should connect to the xCAD
flow connector of the xCAD Server.
c. Connect the second 0.31” (8mm) o.d
hose for the xCAD backflow in the same
way where you have connected in action
a) and b).
6 a. Plug the cable with 25 pin socket into
the socket of the GenPure system and
screw it tight.
b. Plug the other end of the 25 pin cable for
the system control into the xCAD Server
connector.
If applicable use the RS232 connector (13) to
connect the optional data printer.
Step Action Figure
a)
b)
Fitting
White O-ring
Hose 0.31“
(8 mm) o.d
Connection GenPure
system
Hose 0.31“ (8 mm) o.d
Connector xCAD
Server
RS232
25 pin cable
system control
25 pin cable
System control
a)
b)
25 pin connectors system
25 pin connec-
tor xCAD
Server