Thermo Scientific Barnstead GenPure xCAD Plus System, Operating Instructions Manual

Page: 95 / 128

13
Maintenance
Disinfection
Thermo Scientific GenPure
89
5 Push the menu button until “Enter code” is
displayed
The Code to do this transaction please refer from
the Code table under chapter
“Code lock” on
page 82 . You need a level 1 code.
a. Select “Disinfection” from the system
menu and press “Enter”.
b. Confirm the Disinfection Cartridge has
been loaded by pushing “Enter” again
c. The disinfection process will begin.
The disinfection program is finished after approx
30 min and is adjustable in the OEM Menu.
6 Switch the system off and shut off the water
supply.
See step 1.
7 Remove the disinfectant cartridge, empty and dry
it and put in the yellow stoppers that you have
saved for later use. Save the disinfection cartridge
for later use.
See step 5 under chapter “Change the ultrapure
cartridge” on page 85 .
8
Before dispensing water from the system, let
water run out for approx 15 minutes.
The system is then ready for use.
Step Action Figure
a.
b.
c.