Thermo Scientific Barnstead GenPure xCAD Plus System, Operating Instructions Manual

Page: 83 / 128

12
System control
.OEM Menu
Thermo Scientific GenPure
77
Switch temperature compensation off
Temperature compensation can be switched off or on in this menu. TC is shown in the display when it
is switched on, NTC is shown when it is switched off.
Basic setting: Temperature compensation on
After entering the OEM menu press the menu-button 5 times then the display shows:
Set the limiting value for temperature
The maximum temperature which the system is to be allowed to reach is set in this menu. The max.
Temp. error message is triggered when this limiting value is exceeded. A setting can also be made here to
have the system automatically switched over to the Stand-by operating mode to avoid further heating up.
Setting range: 1- 50 °C
Basic setting: 35 °C
Basic setting: Standby: No
After entering the OEM menu press the menu-button 6 times then the display shows:
Rinsing time
The rinsing time can be set in this menu. The system is rinsed automatically every 20 min. when it
works in the “Interval” mode. Additionally in section
“Rinsing the ultrafilter” on page 71 you can read
how to rinse the system manually.
Step width:
1
Setting range: 10 - 60 sec.
Basic setting: 30 sec.
After entering the OEM menu press the menu-button 7 times then the display shows: