Thermo Scientific Barnstead GenPure xCAD Plus System, Operating Instructions Manual

Page: 37 / 128

7
Installation
Installation of GenPure xCAD Plus system, bench version
Thermo Scientific GenPure
31
Installation of GenPure xCAD Plus system, bench version
• Control after installation all tubings that the tubing have the right positions on
the systems panel and there is no any leakage after open the feedwater supply tap.
• To avoid a book trip over the tubings, observe that the tubings are not lay over the floor.
Step Action Figure
1 Either place the system on the intended surface or
hang it on a wall. For wall mounting using the
included wall mounting hardware.
See under chapter “Wall mounting GenPure
xCAD Plus system” on page 46” .
2 Release the cartridge cover by pressing the push
button.
3 Locate the ultrapure cartridge and fit the
cartridge into the system.
4 Push each of the quick connectors onto the
cartridge. You will know they are attached when
an audible “click” is heard.
Fit the cartridge cover on again.
5 Mount the feedwater connecting kit together and
connect it to the feedwater inlet line. Connect the
other end of the hose to the feedwater connector
of the system by unscrew the fitting. After this
put the hose through the fitting and mount the
white O-ring on it. Screw the fitting back to the
system.
Only feedwater that has been pretreated by
reverse osmosis, ion exchange or distillation is to
be used.
Push-button
Cartridge cover
Inlet
Outlet
Ultrapure
cartridge
Quick
connectors
Feedwater connecting kit
White O-ring
Hose 8 mm o.d
Feedwater
connector
unit
Fitting