Thermo Scientific Barnstead GenPure xCAD Plus System, Operating Instructions Manual

Page: 47 / 128

7
Installation
Installation of an additional xCAD Client, bench version (optional)
Thermo Scientific GenPure
41
Installation of an additional xCAD Client, bench version (optional)
You can connect a maximum of two additional xCAD Clients to the xCAD Server.
Step Action Figure
1 Installation the system (see “Installation of GenPure
xCAD Plus system, bench version” on page 31 ).
a. Connect the one end of the 0.31”
(8 mm) o.d hose to the xCAD backflow
connector of the xCAD Server.
The other end of the hose you should
connect it into the xCAD flow connector
of the xCAD Client.
Connect the hose 0.31” (8 mm) o.d into
the xCAD backflow connector of the
xCAD Client.
The other end of the hose you should
connect it into the xCAD backflow
connector of the GenPure system.
b. When you are finished action a) connect
the 9 pin control system cable onto the
9 pin connector of the xCAD Server and
screw it tight.
The other end of the 9 pin system
control cable should be put it onto the
9 pin connector of the xCAD Client and
also screw it tight.
In order to recognise the correct connectors of the
cable on the xCAD Server connect the 9 pin
control cable onto the right port of the xCAD
Server and connecting the other end of the 9 pin
control cable to the left port of the xCAD Client
(see green rectangular).
When the xCAD Client is finish connected to the
xCAD Server the xCAD Server must be in
operating mode (nonstop mode) in order to use
the xCAD Client.
You cannot use the xCAD Client only.
Connecto
r xCAD
Server
Hose 0.31“
(8mm) o.d
Connecto
r xCAD
Client
a)
Hose 0.31“
(8mm) o.d
Connecto
r xCAD
Client
Hose 0.31“
(8mm) o.d
Connector
Server
9 pin system control
cable
Connector
Server
9 pin system
control cable
b)