3
Hardware Upgrades
Dynamic Mixer Installation
Thermo Scientific
Accela 600 and 1250 Pump Hardware Manual
41
Figure 26.
LED cable connection
6. Using a #2 Phillips head screwdriver, remove the four screws that secure the pump chassis
), and then pull the chassis out of the enclosure.
To continue installing the dynamic mixer, go to the next procedure
Dynamic Mixer to the Pump’s Front Panel.”
Tip
The seal wash pump and leak sensor installation procedures also require the removal
of the pump chassis from the enclosure. However, removing the chassis from the enclosure
is not the first step in these procedures.
If you are installing one of these other upgrade options, do the following:
• To continue installing the seal wash pump, go to
• To continue installing the leak sensor, go to
on
.
LED cable connection to the pump’s left door
