2
Configuration Table
Please use the configuration settings listed below when applying the configuration
settings.
Normal Function
Settings
Setting Setting Range
Output ON delay time
F-01
0.00s~99.99s
Output OFF delay time
F-02
0.00s~99.99s
V-I mode slew rate select
F-03
0 = CV high speed priority
1 = CC high speed priority
2 = CV slew rate priority
3 = CC slew rate priority
Rising voltage slew rate
F-04
0.1V~100.0V/s (PFR-100L50)
0.1V~500.0V/s (PFR-100M250)
Falling voltage slew rate
F-05
0.1V~100.0V/s (PFR-100L50)
0.1V~500.0V/s (PFR-100M250)
Rising current slew rate
F-06
0.01A/s~20.00A/s (PFR-100L50)
0.001A/s~4.000A/s (PFR-100M250)
Falling current slew rate
F-07
0.01A/s~20.00A/s (PFR-100L50)
0.001A/s~4.000A/s (PFR-100M250)
Bleeder circuit control
F-09
0 = OFF, 1 = ON, 2 = AUTO
Buzzer ON/OFF control
F-10
0 = OFF, 1 = ON
Detection Time of OCP
F-12
0.0~2.0 sec
Current Setting Limit
(I-Limit)
F-13
0 = OFF (The limit function of current setting
is disabled.)
1 = ON (The limit function of current setting
is enabled.)
Voltage Setting Limit
(V-Limit)
F-14
0 = OFF (The limit function of voltage
setting is disabled.)
1 = ON (The limit function of voltage setting
is enabled.)
Memory Recall Display
F-15
0 = OFF, 1 = ON
Measurement Average
Setting
F-17
0 = Low, 1 = Middle, 2 = High
Lock Mode
F-19
0 = Lock Panel, Allow Output OFF
1 = Lock Panel, Allow Output ON/OFF
USB/GP-IB Settings
Front panel USB status*
F-20
0 = None, 1 = Mass Storage
Rear panel USB status*
F-21
0 = None, 2 = Linking PC
GP-IB Address
F-23
0~30
Show GPIB available
status*
F-25
0 = No GPIB, 1 = GPIB is available
Interface Select
F-29
0 = Disable, 1 = RS232, 2 = R485,
3 = USB-CDC / NO Mass Storage,
4 = GPIB, 5 = LAN SOCKET,
6 = LAN WEB