Funk-Electronic Piciorgros GmbH
TGW-100/TGW-100R
V2.71 - Page 20 of 59
LED
Function
System Pwr
Power supply input
System OK
Indicates the "Ready" status of the modem (continuously lit). Also
indicates error conditions (coded blink sequences).
COM Tx
Lights up while the TGW-100 sends data via the COM interface
COM Rx
Lights up while the TGW-100 receives data via the COM interface
Aux Tx
Lights up while the TGW-100 sends data via the AUX interface
Aux Tx
Lights up while the TGW-100 receives data via the AUX interface
IP Tx
Lights up while the TGW-100 sends data via the Ethernet interface
IP Rx
Lights up while the TGW-100 receives data via the Ethernet
interface
Radio Tx
Lights up while SDS or Status data is being sent to the
infrastructure
Radio Rx
Lights up while SDS or Status data is being received from the
infrastructure
RF
These Led bar indicates the correct registration to the TETRA
infrastructure if the TGW-100 is in SDS gateway mode. During
startup, a yellow LED point runs from the right side to the left
side. As soon as the TGW-100 is registered to the infrastructure,
all 8 LED will light up (this gives the same picture like the TGW-
100 when it's attached to the network with full field strength).
In case of a connection problem, LED 4 flashes continuously. This
indicates that the IP connection to the TETRA infrastructure is lost
or the infrastructure is not responding properly to the
communications from the TGW-100.
PPP Data
not used
PPP Link (blue)
Shows active link to the TETRA infrastructure in SDS gateway
mode
R,E,F1,F2
not used
