8
2.6 Putting into operation
Disable voicemail and notification in SMS about missed calls on the SIM card installed
into the device.
The device
can handle the SIM card’s PIN code. If you wish to use the
PIN code management, configure the SIM card’s PIN code in the programming
software in
the “Device settings / General” section. Otherwise disable PIN code
request on the SIM card.
Check the SIM card to be installed correctly into the device.
Check the GSM antenna to be connected correctly to the device.
Check the wires to be connected as instructed in the wiring diagram.
You can power up the device (12-24V DC). Make sure that the power source is sufficient for
the operation of the
ecoLINE PRO
device. The nominal current consumption of the
ecoLINE
PRO
device is 120mA, however it may increase up to 500mA during communication and
output control. If the used power source is not sufficient for the operation of the device, this
may cause malfunctions.
2.7 LED indicator signals
Slowly flashing green
Normal operation,
connected to the mobile network.
Flashing red
The mobile service unavailable,
or system startup/restart is in progress.
Permanent red
SIM card error.
2.8 Technical specification
Supply voltage range:
12…24V DC
Nominal current consumption:
120mA
Highest current consumption:
500mA @ 12V DC, 250mA @ 24V DC
Operating temperature:
-
20ºC - +70ºC
Transmission frequency:
2G model:
850/900/1800/1900 MHz
3G model:
900/2100 MHz @UMTS, 900/1800 MHz @GSM
3GA model:
800/850/900/1900/2100 MHz @UMTS
850/900/1800/1900 MHz @GSM
4G model:
900/1800 MHz@GSM/EDGE, B1/B8@WCDMA,
B1/B3/B7/B8/B20/B28A@LTE
4GA model:
B2/B4/B5@WCDMA, B2/B4/B5/B12/B13@LTE
Highest load supported on output:
1A @ 24VDC
Modem type:
2G model:
Quectel M95
3G model:
Quectel UG95
3GA model:
Quectel UG96
4G model:
Quectel EG91-E
4GA model:
Quectel EG91-NA
Dimensions:
84 x 72 x 32mm
Net weight:
200g
Gross weight (packed):
300g
