Tektronix RFM150, Instruction Manual

Page: 83 / 278

Making Measurements
RFM 150 Instruction Manual 2–37
Executing Sequences
A series of measurements can be made by executing one of the
automated measurement sequences that are loaded in the RFM 150.
The results of the measurements will be stored, and can be accessed
through the store menu. (To create or import a sequence, refer to
page 3–20.)
24 hour test.
The 24 hour test sequence is installed in the RFM 150 at
the factory and cannot be deleted. When the 24 hour test is executed,
it will make an all channel measurement, using the active channel
table, once every 6 hours. The test is programmed to be performed 4
times. The measurement results will be tagged with the date and
time, and stored as SEQUENCE type.
Editing the sequence parameters.
Press the front-panel SEQ key, then
use the knob to scroll to and select the desired sequence from the list
(Figure 2–17).
SEQ # NAME # OF TIMES DELAY
1 24HOUR 4 6
2 SEQ1 4 1
3 SEQ2 5 1
4 SEQ3 3 1
5 SEQ4 4 1
6 TEST1 5 1
7 TEST2 4 1
8 TEST3 2 1
Outline cursor
indicates selected
sequence. This
sequence will be
acted upon when a
function key is
pressed.
SEQUENCE MENU 17 seq
EXEC
CLONE
SEQ
DEL
DEL
ALL
Function key labels
Total number of sequences stored in the instrument
Figure 2–17: Sequence menu
Select EXEC. A submenu, similar to the one shown in Figure 2–18,
will appear. Displayed on this screen are the current site name and
temperature values with which stored measurement results will be
tagged. If these values are not correct, go to the STORE menu and
enter the correct values now.
Making Measurements
RFM 150 Instruction Manual 2–37
Executing Sequences
A series of measurements can be made by executing one of the
automated measurement sequences that are loaded in the RFM 150.
The results of the measurements will be stored, and can be accessed
through the store menu. (To create or import a sequence, refer to
page 3–20.)
24 hour test.
The 24 hour test sequence is installed in the RFM 150 at
the factory and cannot be deleted. When the 24 hour test is executed,
it will make an all channel measurement, using the active channel
table, once every 6 hours. The test is programmed to be performed 4
times. The measurement results will be tagged with the date and
time, and stored as SEQUENCE type.
Editing the sequence parameters.
Press the front-panel SEQ key, then
use the knob to scroll to and select the desired sequence from the list
(Figure 2–17).
SEQ # NAME # OF TIMES DELAY
1 24HOUR 4 6
2 SEQ1 4 1
3 SEQ2 5 1
4 SEQ3 3 1
5 SEQ4 4 1
6 TEST1 5 1
7 TEST2 4 1
8 TEST3 2 1
Outline cursor
indicates selected
sequence. This
sequence will be
acted upon when a
function key is
pressed.
SEQUENCE MENU 17 seq
EXEC
CLONE
SEQ
DEL
DEL
ALL
Function key labels
Total number of sequences stored in the instrument
Figure 2–17: Sequence menu
Select EXEC. A submenu, similar to the one shown in Figure 2–18,
will appear. Displayed on this screen are the current site name and
temperature values with which stored measurement results will be
tagged. If these values are not correct, go to the STORE menu and
enter the correct values now.