Tektronix RFM150, Instruction Manual

Page: 101 / 278

Reference
RFM 150 Instruction Manual 3–7
Clone Configuration
A quick way to configure an instrument is to copy the configuration
of another RFM 150.
Enter the RS232 menu by pressing UTIL, then F4 (RS232). Make
sure both instruments are set up the same. Connect the supplied
RS-232 cable between the two instruments.
On the source instrument, press UTIL, followed by F1 (CONFIG),
then F5 (CLONE CONFIG). The following instrument parameters
will be sent to the destination instrument:
Active channel table
Active site name
Backlight mode (on/off)
Center level for sweep mode
Center level sensitivity (1 dB/2 dB) for sweep mode
Channel
Detection (average/peak) for meter and spectrum modes
Frequency
High and low pilot frequencies
Measurement mode currently selected
Power down mode
Power units
Power up mode
Preset labels and frequencies
Probe loss
Reference for all channels, meter, and spectrum modes
Resolution bandwidth (RBW) for meter and spectrum modes
Screen contrast level
Screen contrast mode (manual/auto)
Span for spectrum mode
Speaker volume in meter mode
Temperature units
Reference
RFM 150 Instruction Manual 3–7
Clone Configuration
A quick way to configure an instrument is to copy the configuration
of another RFM 150.
Enter the RS232 menu by pressing UTIL, then F4 (RS232). Make
sure both instruments are set up the same. Connect the supplied
RS-232 cable between the two instruments.
On the source instrument, press UTIL, followed by F1 (CONFIG),
then F5 (CLONE CONFIG). The following instrument parameters
will be sent to the destination instrument:
Active channel table
Active site name
Backlight mode (on/off)
Center level for sweep mode
Center level sensitivity (1 dB/2 dB) for sweep mode
Channel
Detection (average/peak) for meter and spectrum modes
Frequency
High and low pilot frequencies
Measurement mode currently selected
Power down mode
Power units
Power up mode
Preset labels and frequencies
Probe loss
Reference for all channels, meter, and spectrum modes
Resolution bandwidth (RBW) for meter and spectrum modes
Screen contrast level
Screen contrast mode (manual/auto)
Span for spectrum mode
Speaker volume in meter mode
Temperature units