Preparation for Use
MTD200 MPEG Test Decoder User Manual
3–9
The level is set with the aid of links on the MPEG decoder board.
The following output levels may be set:
+ 6 dBu
+ 9 dBu
+12 dBu
+15 dBu
The unit is factory-set to +6 dBu. To set another level the unit must be opened as
described in Fitting a Key Card on page 3–7. In addition, the upper screen
cover must be removed. To do so, loosen the 8 Phillips screws. The level can
now be set for both “left” and “right” by positioning the links as shown on the
screen cover (see Figure 3–2).
+6 dBu
+9 dBu
+12 dBu
+15 dBu
Front
Rear
Figure 3–2: Setting the audio level
Setting the Level of
Analog Audio Outputs
Summary of Contents for MTD200
