Tektronix MTD200, User Manual

Page: 57 / 211

Preparation for Use
3–6
MTD200 MPEG Test Decoder User Manual
Installation
CAUTION.
To prevent damage to the instrument, ensure that the following
conditions are met prior to operating the MPEG test decode:
The earthing contact is connected to protective earth.
The ventilation openings are not obstructed.
The signal levels applied to the inputs are not above the permissible limits.
The outputs of the instrument are not overloaded or improperly connected.
Desktop Model.
The measurement decoder is intended for indoor use. The
following site requirements must be met:
The ambient temperature should be b 5 and + 45
°
C.
The ventilation openings and the air outlet on top of the unit must be
unobstructed.
For use in the lab or on a desk, fold down the feet at the bottom of the unit.
Accommodation in a 19-inch Rack.
CAUTION. When mounting the unit in the rack, make sure that the air flow (air
inlet and outlet at perforations) is not obstructed.
To install a standard MPEG test decoder in a 19-inch rack, you can use Rack
Adapter (part number ZZA91 or Option 1R). Mounting instructions are supplied
with the adapter.
To avoid electromagnetic interference, the unit should be closed when in use.
Only suitable shielded signal and control cables may be used.
The MPEG test decoder can be operated on an AC supply from 100 to 240 V at
frequencies of 47 to 63 Hz. The power connector is located at the rear of the unit
(see Table 3–2 on page 3–4).
When a monitor is connected to one of the analog or digital video outputs, the
MPEG test decoder can display characteristics and errors of the applied transport
Setting up the Unit
EMC Safety Precautions
AC Supply Voltage
Connecting a Monitor