Maintenance and Checking
MTD200 MPEG Test Decoder User Manual
6–5
6. Closing the instrument:
a. Put upper RF cover onto decoder board and screw it on.
b. Slide on top cover from the rear.
c.
Put instrument upside down.
d. Put lower RF cover onto decoder board and screw it on.
e.
Slide on bottom cover from the rear.
f.
Put back feet on rear panel and screw them on.
After this date and time have to be newly set.
g. Switch on instrument.
h. Set date and time in the SETUP menu.
S
D
E
A
T
T
U
E
P
+TI
-
M
1
E
4-
1
M
0
A
:
R
3
-
2
9
:
6
21
b
y
selecting DATE and TIME
'
a
selecting individual elements
ENT
entry mode
ESC
return to main menu
Checking
Upon power on, the instrument starts a BOOT procedure with a memory and
hardware check. If a fault is detected, a message is displayed on the LCD.
In the case of a total failure, send the instrument to your local service center.
Summary of Contents for MTD200
