Appendix A: Interfaces
A–4
MTD200 MPEG Test Decoder User Manual
Audio Outputs
An audio program can be selected from the transport stream multiplex. This
program is then decoded and made available as an audio signal at the LEMO
connectors mentioned below. A digital/serial signal to AES/EBU as well as two
analog signals L and R are available.
The LEMO connector for this audio output is provided at the rear of the unit and
is designated AES/EBU. The connector has an output impedance of 110
W
, the
output level is 4 Vpp (
±
10%).
The two LEMO connectors for the output of the audio channels are provided at
the front and rear of the unit (‘Audio1/L’ = tone 1/left channel and ‘Audio2/R’ =
tone 2/right channel). The connectors have an output impedance of < 50
W
, the
output level is +6 dBu (default) and can be increased after opening the unit by
repositioning two jumpers to +9/12/15 dBU (refer to Setting the Level of Analog
Audio Outputs on page 3–9).
Digital/Serial Audio Output
– AES/EBU
Analog Audio Outputs –
Audio1/L , Audio2/R
Summary of Contents for MTD200
