Tektronix MTD200, User Manual

Page: 121 / 211

Remote Control
5–24
MTD200 MPEG Test Decoder User Manual
Command Notes Unit Parameter
READ
:ARRay
:PROGram? –
/ 1 to 65535 {, 1 to 65535}
Reads the number of the programs in the
transport stream.
:PID? 1 to 65535
/
0 to 8191 {,0 to 8191} Queries the PID numbers of all program
elements. The first number is the PID of
the PMT, the second is the PCR PID.
READ
[:SCALar]
:PID
:TYPE? 0 to 8191
/
VIDeo | AUDio | DATA | PSI | SI
Queries the type of an element.
:BITRate? 0 to 8191
/
0.0 to 99.999E6
bit/s
Queries the bit rate of an element
:CONDaccess? 0 to 8191
/
1 | 0 Queries whether an element is encrypted.
ROUTe
:VIDeo[?] PALNtsc | SECamntsc
Sets the video standard for a 625-line
signal
:AUDio
:RIGHt[?] ON | OFF
Audio output 1/right off/on
:LEFT[?] ON | OFF Audio output 2/left off/on
SENSe :PROGram 1 to 65535
This command selects the program to be decoded via the program number. PID
values for PCR, video, audio and data are taken from the PMT.
Example: SENS:PROG 1
SENSe :PROGram :PCR 32 to 8191
Sets the PID for the PCR values of the decoded streams. This setting is only
required when the PMT is faulty.
Example: SENS:PROG:PCR 100
SENSe :PROGram :VIDeo 32 to 8191
Sets the PID for the video stream to be decoded. This is only required if the
program contains more than one video stream or if the PMT is faulty.
Example: SENS:PROG:VID 100