111
Setting up external sensors
DL-Bus sensor
Designation
Each sensor can be given its own designation here. This designa
-
tion only serves the purpose of identification and has
no influence
on operation.
Source
The source from which the signal is being read out. In this case, „DL
input“ as chosen for a sensor in the DL-bus.
DL-Bus address
The address of the sensor in the DL-Bus.
DL-Bus index
Index of the external sensor‘s desired value. The instruction manu
-
al of a DL-Bus sensor has further details about the sensor‘s values
and its indices.
Sensor correction
Correctional value in 1/10 degree steps (1 = 0.1°C)
Sensor check
With sensor check activated („Yes“) an error message is automati
-
cally generated to indicate short circuits or sensor interruptions,
found in „System status“ in the overview.
The measured value is displayed at the end of the menu.
Value of a CAN-Bus device
Designation
Each sensor can be given its own designation here. This designa
-
tion only serves the purpose of identification and has
no influence
on operation
.
Source
Source of the signal. For this case, „CAN analogue input“ was cho
-
sen, because the value is taken over from another CAN-Bus device.
Alternatively, „CAN digital input“ can be chosen. Analogue inputs
are measurements, digital inputs are Yes/No or On/off signals.
Node number
Input of the CAN node number of the respective device, as well as
the desired
Output number.
Sensor check
In addition to outputting a sensor error message (in case of inter
-
ruption or short circuit), a CAN network error can be displayed.
The values of external inputs can be assumed by sensor inputs for
further operation. For this application, the sensor must be set to
„Sensor accept“ in the
Sensor menu
and the respective external in
-
put must be chosen under „Sensor assignment“.
Summary of Contents for UVR65
Page 2: ......
