TEC B-SX4T Series, User Manual

Page: 100 / 316

APPENDIX 1 SPECIFICATIONS
ENGLISH VERSION EO1-33036
A1.3 Media
EA1- 4
A1.3.2 Detection Area of the Transmissive Sensor (Cont.)
<Tag paper with square holes>
A1.3.3 Detection Area of the Reflective Sensor
The Reflective Sensor is movable from the centre to the left edge of media.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm.
The Reflective Sensor should be aligned with the centre of the Black Mark.
A1.3.4 Effective Print Area
The figure below illustrates the relation between the head effective print width and media width.
Sensor should be positioned at
the centre of the black mark.
Centre of media
Min. 12 mm
Media feed direction
Min. 2.0 mm
Sensor is movable
within this range.
6.0
mm
140 mm (Max. media width)
128.0 mm
±
0.2
(Head Effective Print Range)
Out of print range
Out of print range
6.0
mm
Detecting the black
marks on the back.
Sensor position
Centre of media
Min. 12 mm
Media feed direction
Min. 2.0 mm
Sensor is movable
within this range.
Square holes
(Round holes are not acceptable.)
Print side
NOTE:
Round holes are not acceptable.