TEC B-SX4T Series, User Manual

Page: 213 / 316

5. SYSTEM MODE
EO18-33012A
5.4 PARAMETER SETTING
5-24
NOTES: 1. If the printer is not used for a few days, the top edge of the media may become curly,
resulting in a paper jam. The Auto Forward Wait Function prevents this problem since
the media feed amount is increased so that the media stops past the platen.
2. When the Stop Position Fine Adjustment Value is set to + direction, the media will stop
past the media outlet.
When the value is set to – direction, the media will stop inside the media outlet.
3. This setting will be useful to fine adjust the cut position of labels.
5.4.10 Head Up Cut/Rewinder Selection
With this parameter you can select the print head up in cut mode or the use of the Rewinder.
When “<2>PARAMETER SET” appears, press the [PAUSE] key and the [FEED] key 9 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Head Up Cut/Rewinder, press the [PAUSE] key.
NOTES: 1. In cut mode, you can select ON/OFF status of the head up. In batch mode, you
can select the use of the built-in Rewinder.
2. In cut mode, be careful that the head up is unavailable depending on the rise of
the solenoid’s temperature.
5.4.11 Ribbon Saving Function Selection
With this parameter you can select the ribbon saving function. When “<2>PARAMETER SET”
appears, press the [PAUSE] key and the [FEED] key 10 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Ribbon Saving Function, press the [PAUSE] key.
NOTE: When setting this function to ON, be sure to install the ribbon saving module (option: B-SX4T).
Failure to do this may slacken the ribbon, causing print failures .
!3$5$0(7(5 6(7
+8 &875:' 2))
[RESTART]
[FEED] +8 &875:' 21
Head up is ON or the Rewinder is used.
+8 &875:' 2))
Head up is OFF or the Rewinder is not used.
!3$5$0(7(5 6(7
5,%%21 6$9( 21
[RESTART]
[FEED]
5,%%21 6$9( 2))
Unavailable
5,%%21 6$9( 21
Available